The TP-Link TL-SG1218MP is an unmanaged switch with 18 Gigabit RJ45 ports, 16 of them PoE (250 W budget), plus two Gigabit combo SFP slots.
The TP-Link TL-SG1218MP is an unmanaged switch with 18 Gigabit RJ45 ports, 16 of them PoE (250 W budget), plus two Gigabit combo SFP slots, in a 1U 19-inch rack-mountable steel case. It is plug and play, so it works out of the box with no configuration.
The TL-SG1218MP is a PoE switch for powering and connecting IP cameras, Wi-Fi access points and VoIP phones over a single network cable. TP-Link list a PoE budget of 250 W shared across its 16 PoE ports, using 802.3af/at PoE+.
For CCTV, a typical fixed IP camera draws around 7 W or less, so the TL-SG1218MP can power roughly 16 cameras at once (check each camera's datasheet; PTZ and heated cameras draw more). TP-Link's Extend Mode allows PoE and data up to 250 m on the supported ports, at reduced speed, for cameras beyond the normal 100 m limit. For larger runs, see our full range of network switches.
| Model | TL-SG1218MP |
| Hardware version (supplied) | 5.40 |
| Standards and Protocols | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3af, IEEE 802.3at, IEEE 802.3z, IEEE 802.1p |
| Interface | 16× PoE+ gigabit RJ45 ports; 2× gigabit non-PoE RJ45 ports; 2× combo gigabit SFP slots |
| Network Media | 10BASE-T: UTP category 3, 4, 5 cable (maximum 100m); EIA/TIA-568 100Ω STP (maximum 100m); 100BASE-TX: UTP category 5, 5e cable (maximum 100m); EIA/TIA-568 100Ω STP (maximum 100m); 1000BASE-T: UTP category 5, 5e, 6 or above cable (maximum 100m); EIA/TIA-568 100Ω STP (maximum 100m); 1000BASE-X MMF, SMF |
| Fan Quantity | 2 |
| Physical Security Lock | Yes |
| Power Supply | 100–240 VAC, 50/60 Hz |
| PoE Ports (RJ45) | Standard: 802.3at/802.3af compliant; PoE Ports: Ports 1–16; PoE Power Budget: 250 W |
| Dimensions ( W x D x H ) | 17.3 × 7.1 × 1.73 in (440 × 180 × 44 mm) |
| Mounting | Rack Mountable |
| Max. Power Consumption | 19 W (220/50 Hz. no PD connected); 293.34 W (220/50 Hz. with 250 W PD connected) |
| Max Heat Dissipation | 64.79 BTU/h (no PD connected); 1000.29 BTU/h (with 250 W PD connected) |
| Packet Buffer Memory | 4.1 Mbit |
| Advanced Features | Compatible With IEEE 802.3af/at Compliant PDs; 802.1p/DSCP QoS; Mac Address Auto-Learning And Auto-Aging; IEEE802.3x Flow Control For Full-Duplex Mode And Backpressure For Half-Duplex Mode; Extend Mode (Ports 1–4, Up to 250 m PoE power supply and data transmission); Priority Mode (Ports 1–4); Isolation Mode (Ports 1-8/9-16); PoE Auto Recovery (Ports 1-16) |
| Jumbo Frame | 10 KB |
| Switching Capacity | 36 Gbps |
| Packet Forwarding Rate | 26.78 Mbps |
| MAC Address Table | 8K |
| Certification | CE, FCC |
| Package Content | TL-SG1218MP; Installation Guide; Power Cord; Rackmount Kit; Rubber Feet |
| Environment | Operating Temperature: 0–50 °C (32–122 °F); Storage Temperature: -40–70 °C (-40–158 °F); Operating Humidity: 10–90% RH non-condensing; Storage Humidity: 5–90% RH non-condensing |
You need network cable for each device. Total PoE draw of all connected devices must stay within the 250 W budget. SFP modules for fibre uplinks are sold separately.
We are a supplier, not an installer. We will go through the TL-SG1218MP with you before you buy — the port count and speed against your devices and the PoE budget against your cameras or access points — and depending on your requirements and your area we can recommend a qualified trade installer. We have been operating since 2012 and you can visit our trade counter in Wolverhampton.
TP-Link list a 250 W PoE budget across 16 PoE ports. At around 7 W per typical fixed IP camera that is roughly 16 cameras; higher-draw PTZ or heated cameras reduce that number.
The PoE ports are 802.3af/at compliant, so they power standard PoE (15.4 W) and PoE+ (30 W) devices. They will not power 24 V passive PoE devices.
Unmanaged. It is plug and play with no web interface or VLAN settings.
No, it cannot be adopted or managed by an Omada controller, though it will pass Omada traffic like any switch. If you want Omada management, look at the ES220GP easy managed switch.
Yes: two Gigabit combo SFP slots.
Yes. It has a 1U 19-inch rack-mountable steel case.
The TL-SG1218MP has 18 Gigabit RJ45 ports, 16 of them PoE (250 W budget), plus two Gigabit combo SFP slots. The TL-SL1218MP has 18 10/100 Mbps RJ45 ports, 16 of them PoE (250 W budget), plus two Gigabit RJ45 ports and two Gigabit combo SFP slots.
We ship nationally from our multi-million pound warehouse, with orders leaving daily. Orders placed before 2:30pm are normally dispatched for delivery within 1–2 working days to England, Scotland and Wales. You can also collect in store from our trade counter — call first so we can confirm your order is ready. We do not ship to Northern Ireland.
Yes. Our trade counter is at Unit 3, Park View Centre, 243 Dudley Road, Wolverhampton WV2 3JU. Call first so we can confirm the item is there for you.
Questions on specification or compatibility: call 01902 902251, see our FAQ and support pages, or contact us. Trade accounts are available — see trade customers. Browse the full TP-Link range.
Official TP-Link VAR Partner: Zenith Security Co is listed on TP-Link's UK where-to-buy page as a VAR Partner, so this is genuine UK-supplied TP-Link equipment. See our full TP-Link range.
| Product Code | TL-SG1218MP |
|---|---|
| Dimensions | 440 × 180 × 44 mm |
| Manufacturer | TP-Link |
| Colour | Black |
| Device Port Speed | 10/100/1000 Mbps |
| Power Features | PoE out 802.3af/at, 250 W budget; 100–240 VAC, 50/60 Hz |
| Connection Type | Wired |
| Device Ports | 18 |
| Managed | No |
| PoE Ports | 16 |
| Uplink Ports | 2 |
We provide tailored support for you and your CCTV system.
Many of our Cameras and Recorders come with a comprehensive 3 year warranty.
We've got a fully functioning show room and IP suite to show you exactly how our CCTV equipment works
As cheap as £10, orders placed before 2:30pm are dispatched for delivery within 1–2 working days!
